Popular Articles
Flickering Lights
If the lights are flickering, it can be caused by any of these issues: Lack of Power This is usually due to having the brightness turned too low. Try turning it up. Also check your power injection points. Long Jump over 30 FT If you have made a large ...
WLED Connectivity Issues
*** If your Controller has connected in the past but is no longer connecting, it is possible your home router issued a new IP Address for the controller board, if this is the case, you can go into WLED and delete the current item by hitting the trash ...
Box has power, but fuse LED is out / Fuses are blown
If your box has power, but the LEDs next to the fuses are off, you may need to replace some fuses and check your power injection: Check the Fuses Unplug your controller box and remove the lid. Plug the controller box back in but DO NOT TOUCH ANYTHING ...
Last light before or after a jump stays on even when turned off
If you made a jump or branch and a single LED is staying on even though you have turned off the lights in the WLED app, it's most likely because the red and green wires touched together with the power on. This most often happens when wires are cut ...
Lights show "Offline" in WLED when they were previously working
If your lights were previously working fine, but now show as "Offline" inside the WLED app the IP address of the controller probably changed. This will happen if the controller lost power or a decent amount of time has passed. You can prevent this ...